#Ethernet adapter mac address windows xp keygen
For the Secondary DNS server, you could leave it blank or type in 8.8.8.8. The Preferred DNS server is the same as to default gateway. Step 5.There are two ways to configure the TCP/IP Properties, Assigned by DHCP server a utomatically or manually.ġ) Select Use the following IP address, type IP address, subnet mask and default gateway IP address into it. Double-click on Internet Protocol Version 4 or click Properties. Highlight and right-click on Ethernet, then select Properties. Click on Network and Internet -> Network and Sharing Center, click on Change adapter settings on the left side. Press Windows key + X at the same time and select Control Panel. Step 5 Click OK to save and apply your settings. The Preferred DNS server is the same as the default gateway. Note: In most cases, type your local area DNS server IP addresses into it. If necessary, then click OK to save the settings. And then type the DNS server IP address, which should be provided by your ISP. If necessary, then click OK to save the settings.ġ) Select Use the following IP address, type the IP address, subnet mask, and default gateway IP address into it.Ģ) Select Use the following DNS server addresses, as shown in the following figure. Select Obtain an IP address automatically and Obtain DNS server address automatically. There are two ways to configure the TCP/IP Properties, Assigned by DHCP server a utomatically or manually. Step 3.Select Internet Protocol Version 4(TCP/IPv4), double click it or click Properties. Highlight and right-click the Local Area Connection icon and select Properties. In the task list, please click Manage network connections (for Windows Vista )/Change adapter settings (for Windows7 ). Click Start -> Control Panel -> Network and Internet -> Network and Sharing Center. Click OK to save and apply your settings. Finally, remember to click OK to save settings. If the router’s LAN IP address is 192.168.1.1, please type in IP address 192.168.1.x （x is from 2 to 253）, subnet mask 255.255.255.0, and default gateway 192.168.1.1.Ģ) Select Use the following DNS server addresses, as shown in the following figure. Then click OK to save setting.ġ) Select Use the following IP address, as shown in the following figure. Select Obtain an IP address automatically and Obtain DNS Server address automatically, as shown in the figure below. Step 4.Now you have two ways to configure the TCP/IP protocol below: The TCP/IP Properties window will display. Highlight the Internet Protocol (TCP/IP) tab, and then double click it or click Properties. Click the Properties button to open up the properties window.
Step 2.Highlight and right-click the Local Area Connection icon c lick on Status and go to General. *Note for laptop users: If you do not have "Ethernet Adapter Local Area Connection", please look under "Ethernet adapter Wireless Network Connection." However, if you use the Physical Address under the Wireless Network Connection and turn off or disable your wireless card or device, the product may not function until it is re-enabled.Step 1.Click Start->Control Panel->select and double click Network and internet connections (If you can´t find it, please go next) ->select and double click Network Connections. Under the Ethernet Adapter Local Area Connection section, look for the “Physical Address”. In the Command Prompt window, type ipconfig /all and Press Enter. Click on the Start Menu, then select Run. Under the Ethernet Adapter Local Area Connection section, look for the "Physical Address". In the Command Prompt window, type ipconfig /all and press Enter. Click on the Start Menu, and in the Search box, type cmd then press EnterĢ. Click on it to open the Command Prompt.Ĥ. In the results, find Command Prompt on the left. Type cmd and make sure you have Apps selected (not Settings or Files).ģ. It is a unique set of letters and numbers that identifies your network card and computer.Ģ. "MAC" stands for Media Access Control, and is also known as a Physical Address.
0 kommentar(er)
